Enable cdp

Опубликовано: 17.05.2017

видео enable cdp

CDP, LLDP

If you are familiar with managing VMware ESX 3. 5/4.x in an environment that includes Cisco LAN switches then you have probably used “CDP listen state” that is enabled by default on an ESX install. To view this information in vCenter select an ESX host, go to the configuration tab in the right pane, select the Networking link and then click on the little blue call out box next to a vmnic that is uplinked to a vSwitch. A pop-up window opens displaying the CDP information. The information can be invaluable when troubleshooting networking issues. You can determine which switch/switch port the NIC is plugged into, native VLAN and other useful information. This is also a great way to verify that your vSwitch uplinks are going to 2 different physical switches (if you have that option).

 

 

 

As I stated earlier the default CDP configuration on an ESX vSwitch is the listen only state. I have found that the network engineers find it very useful if you configure CDP to advertise as well. When you enable this on a vSwitch the network engineer can issue the “show cdp neighbors” command from the IOS command line and witch switch ports each ESX vmnic is plugged into. This can also be very useful when you and the network engineer are troubleshooting network issues with ESX.

To configure CDP to advertise run this command from the ESX console or from an SSH session.

“esxcfg-vswitch -B both vSwitch0”

To check the state of the CDP configuration run this command. .

“esxcfg-vswitch -b vSwitch0”

Note – you must источник. on all vSwitches if you want to see every vmnic from the switch side.

If you are using a VMware vNetwork Distributed Switch then you can configure the CDP state from the vCenter GUI. To do this go to the edit settings on the dvSwitch and then go to Advanced.

 

 

Ok, now to the point of configuring all of this on Cisco UCS blades.

By default the vNICs in Cisco UCS have CDP listen and advertise turned off. You can see this from an ESX host that is running on a UCS blade by clicking on the little blue call out box. When the pop-up opens it states that Cisco Discovery Protocol is not available.

 

 

To enable CDP the first thing you must do is to create a new Network Control policy. To do this go to the LAN tab in UCSM, expand Policies, right-click Network Control Policies to create a new policy. Name it something like “Enable-CDP” and select the option to enable CDP.


How to enable cdp globally on cisco router


CDP - Cisco Discovery Protocol - CCNA in Hindi